Ok, so I'm new in here, I've had my grizzly for about 12 years. I absolutely love it, I started having problems with it and long behold had the top end rebuilt new starter, cdi ect. Sat for 4 years because well you know LIFE happens. Anyway I want to get her back up and me riding again. I...

Hey guys, i was looking at my grizz earlier tyoday and noticed in is leaning a bit to the left on the rear. I have checked the tire pressure and everything looks good, and couldn't see anything else obvious that would cause this. When looking from the front everything looks level. Anyone know...

I installed a new mikuni carb on my 2011 450 grizzly EPS . It started right up but is idling high . I adjusted the idle screw no help checked throttle and choke cable seem to be operating fine.I do have a question about the choke i think there where two plungers in the carb I looked on line and...

BTC Miner Antminer S19 Pro 110 Th/s + PSU : $2,500 USD Antminer S19j 90Th/s - $1,500 usd Antminer S17 Pro 56TH/S : $1000 usd Antimer T17+ : $800 usd ETH Miner Innosilicon A10 Pro+ 750 Mh/s : $3,500 USD ETH Miner Innosilicon A10 Pro 500 Mh/s : $3000 USD ETH Innosilicon A11 Pro 2000 Mh/s...

So of course I broke two of the clutch cover bolts when I opened it up to check everything out. Its one of the long ones and one short one. I still have to try to extract them, but wondering if I can grab some at the hardware store, or if I have to order them. I tried to look them up, but cant...