Grizzly Riders Forum banner
2011
1-19 of 250 Results
Advanced
  1. Grizzly Chassis & Body
    Hi, I have a 2011 grizzly 700 and need to replace the fuel pump, which is located under the seat, on top of the tank. The rear plastic fender has a hole in it that is smaller than the top of the fuel pump diameter and access to the nuts holding the pump in is hard. Do I need to remove the whole...
  2. Grizzly Specifications
    Hi all, after some advice. I have bought a Grizzly and been running fine until today. Its started sounded louder and almost a knocking coming from the engine when on tick over. Any ideas? I have it on a trailer heading to a local dealer but thought I'd ask if anyone has had similar, oil was low...
  3. Grizzly Tech Tips
    2011 Grizzly 550: After a hard rain storm or trailering the machine in wet conditions, the bike will not start until some period later when conditions have dried. This has occurred in late spring and fall (warm and cold conditions). The battery is good! Starter is good. No harness issues that I...
  4. ATVs For Sale
    2011 Yamaha Grizzly 700 4WD Yammy Blue 194 miles/27.9 hours and garage kept Warn XT25 winch with synthetic rope Has never seen mud, I rode it in the mountains of Utah on just a few trips, some scratches on fenders Newer Duracell AGM battery that sits on a trickle charger Comes with arched truck...
  5. Grizzly Chassis & Body
    I have a 2011 550 grizzly with a warn front mount plow system.My question is, does anyone make a front bumper-brush guard that will bolt in place with the warn front mount plow bracket in place.I like the looks of the moose one, but it looks like it bolts to the same holes as the plow mount bracket.
  6. Grizzly Tech Tips
    Well looks like the cold weather got my battery in my 2011,700 grizz can somebody tell me the biggest cca battery that will fit my bike and best place to buy it please. Thanks bob in tn
  7. Grizzly Talk
    Ok having starter issues. push button sometimes starts fine other times it acts like a bad battery. Very slow to turn over and sometimes just doesn't turn over at all. Put in new battery new starter new solenoid. Would a one way bearing cause this? zenchal26 is online now
  8. Grizzly Talk
    I used my grizzly last winter for grooming and the Actuator on the drag fried the wire harness.. I replaced the Harness , Battery , the Coil , New plug and i still have no spark , There is power to the coil , power to the plug tested with my multi meter.. It turns over but I cant get it to...
  9. Grizzly Engine & Transmission
    Hello all, 2011 Grizz 450 Stock no mods. 142 ft elevation Working on the Grizzly for a friend, looking for some help. It sat for a year or more in his shed. Trying to troubleshoot on the cheap since he's on a low budget. Can't for the life of me get her right. Compression is looow at ~95-120psi...
  10. Grizzly Engine & Transmission
    Just bought a used 2011 Grizzly 550 EPS 4WD. Previous owner installed a HMF Penland Pro series exhaust on it and the HMF optimizer. It is way too loud for me - I'm trying to do yard work and not annoy the neighbors or make my family deaf. It already has the "Quiet Core" baffle installed and it...
  11. ATVs For Sale
    2011 Grizzly 450 4x4 EPS Camo for sale. 512 miles 70.8 hrs. Garage kept, used for light trail riding and hunting. Never wrecked, no mudding, wheels removed & washed, lubed, after every use. Has gun holders,Venom 2500HD winch, shock cover's, camo seat cover & fender flares, added pull cord start...
  12. Grizzly Chassis & Body
    Just purchased this kit from Kolpin which comes with the most unbelievably useless installation instructions I've encountered of late. Anyone ever installed one of these that could post a couple pictures?
  13. Grizzly Engine & Transmission
    Searched the forum but unable to find help on my issue so here goes 2011 Grizzly 700 starts and idles fine in Neutral and Park but as soon as I put it into any gear it stalls. Not sure what to think. Any ideas electrical, clutch, fuse ... Looking forward to all your great wisdom Thanks
  14. Grizzly Engine & Transmission
    Hello all.. A couple of questions... I have been lucky enough to have my grizzly since 2011 and not had any fights with trees... Well that came to an end, lol.. Anyway, it died the winch broke and fried the winch wires, contactor and battery. It did not hurt the frame just plastics on drivers...
  15. Grizzly Talk
    Hi everyone. I saw this forum and you guys might be able to help. A friend of mine took his 2011 450 grizz to a Yamaha dealer because it was smoking again. This the 3rd time its been rebuilt. The dealer quoted him $5700. what on earth would cost that much. How much would a new motor cost?
  16. General Discussion
    I have a 2011 grizzly, I was riding when I noticed the lights flicker, then my speedometer stopped, then smoke, electrical burning smell, shut down immediately but would not stop. It finally died. Got it home disconnected battery, let cool down overnight. I plug battery back in, and I can start...
  17. Grizzly Tech Tips
    I totaled my 450 a while back instead of junking it i bought a new frame and swapped everything over and good as new. What i didnt catch was a small tare in my rear inner cv boot so i went out riding and didnt catch it till i was unloading back at my house. I ordered a cv boot kit and I replaced...
  18. Grizzly Engine & Transmission
    I am trying to find the correct part# for a Twin-Air air filter for my 2011 Grizzly 550. The part# I have is 152912. Are the images I see not representing the actual filter? I am expecting the filter to look like the stock filter, big and flat. All of the images I see are of a baseball hat...
  19. Grizzly Talk
    Hello everyone I am going to try to perform and change all my oils and lubricants on my machine. what are the best fluids to use and what would you recommend? where to buy, capacities and price. Thanks in advance. Steve
1-19 of 250 Results
Top