Grizzly Riders Forum banner
axle
1-19 of 66 Results
  1. Grizzly Talk
    Hi,thank you for having me. My father has a 08 Yamaha Grizzly 660 and he told me the cv boots of front axles were broken yesterday. And he couldn't find cv boots at local repair shop.So I try to buy it online for him. Many posts said for this case just buy cv axle boot replacement then replace...
  2. Grizzly Talk
    I have a 07 Yamaha Grizzly 450. One of axle was Broken suddenly on yesterday.Bad....Luckily, safe no hurt.After checked ,it's rear left. I've been reading a lot of article or posts online and I see a lot of guys also had the same problem before. So do I need to buy two axles ( keep another one...
  3. Grizzly Engine & Transmission
    Hey everybody, This is my first post. I have a 2003 660 that I am replacing some oil seals on due to leaks. The ones that were leaking were the rear seal where the driveshaft comes off the motor and where the front driveshaft goes into the front diff. I got the rear driveshaft all squared away...
  4. Kodiak/Big Bear/Bruin/Wolverine Discussion
    So i got a 92 Big Bear 350 and im going through the whole thing. Ive had it for a few years and have not been easy on it. Yet she stills goes whereever i need it to. I checked my rear diff fluid and its full of mud etc. Im trying to remove the axle and im having no luck. I have not had any...
  5. Grizzly Talk
    Hey everyone, I haven't posted in a while which means everything is going great with the machine, except.. Today before our ride I was doing my normal inspection to make sure nothing looks wrong. I was checking on the front axles when i noticed the front left side was a bit weird. I have...
  6. Kodiak/Big Bear/Bruin/Wolverine Discussion
    Just bought a 99 Kodiak about a month ago. Ive been going through it, changing fluids and all. When I went to change the rear differential fluid I found the plug was stripped out. I managed to get it out with some vise grips. The oil that came out was super thick and smelled horrible. When I say...
  7. Grizzly Engine & Transmission
    hey guys, new to the forum. i am helping a friend with his grizzly as we are trying to go ride this saturday! we have ran into a problem last week. he has a 2 inch high lifter lift, and 28 inch ITP mega mayhems. he right side factory axle broke so he ordered an upgraded outlaw axle from high...
  8. Grizzly Chassis & Body
    Ok...so I just put on MSA Kore 14" rims and Mega Mayhem 27" tires. Tonight I put on a Highlifter 2" lift kit and after looking at the angle of the axles, it has me a little worried. Here are a couple pics. Do these seem angled too much and should I remove the lift? Thanks.....
  9. New Member Introductions
    I have a 2012 grizzly 550 and I had the outer cv axle boot rip and I am going to replace the in tire cv axle. I was wondering what years would match up to the 2012 thank.
  10. Grizzly Tech Tips
    I totaled my 450 a while back instead of junking it i bought a new frame and swapped everything over and good as new. What i didnt catch was a small tare in my rear inner cv boot so i went out riding and didnt catch it till i was unloading back at my house. I ordered a cv boot kit and I replaced...
  11. Grizzly Engine & Transmission
    Finally got around I installing my surtrack axles I got off eBay. Got them for $209 for set of rears. Some things to know they are made in china. Seller told me 1 year warranty against defects but there is a youtube video of Surtrack at a show saying lifetime warranty may need to research a...
  12. Grizzly Tech Tips
    I need some help my right rear axle keeps popping out on my 660 grizzly. It's a gorilla axle I have tryed bending out the stock clips that didn't work. I upgraded the clips to the gorilla sqaure clips that didn't work. I have the rear support brace added. I always fill my diff untill it...
  13. Grizzly Engine & Transmission
    My left side axle shaft keeps popping out , I've changed fluid , circlip, cleaned and re packed c.v ..splines are good , bearings are good , ball joint is good, .. Any ideas. The bike is a 2005 660 with 800 Kms and completely stock. I just bought it and have only gone for one ride . I'm beyond...
  14. Grizzly Tech Tips
    I'm trying to remove a broken axle and replace it. I've done it on other models but never my yamaha. How do I get the large nut off the end? It has some sort of metal tab that fits into a groove that prevents it from spinning. I've even got an impact wrench in my friends garage and it won't...
  15. General Discussion
    Hello everyone. I am in need of rear cv axle specs. Mainly inboard spline count and diameter. It is being used on an all Yamaha parts gokart with an fzr600 engine. It is mostly built except for the rear independent suspension. Any year with a cv rear axle. Thank you
  16. Grizzly Chassis & Body
    Hey everyone, Just a quick question. I have an 06 660 grizzly and my right front axle actually sheared just inside the case. if i pull off the other side can I punch it out or would i have to split the case? metal to hard to drill I'm sure, but I think I'nm going to end up splitting the case...
  17. Grizzly Talk
    I was riding my 06 660 Grizzly a couple of weeks ago and the left rear axle came out of the differential. I didn't know it came out, till I was climbing a seemingly harmless grass hill and it kept going left right into and under a cedar tree. I was like "?what the crap!?" I backed down the hill...
  18. Kodiak/Big Bear/Bruin/Wolverine Discussion
    Hey guys. I might be buying a 2007 Big Bear IRS tomorrow morning that needs a rear axle. Are the axles from the Kodiak/Grizzly 450 interchangeable with the Big Bear or are they model-specific? Thanks,
  19. Grizzly Chassis & Body
    Hi! Does anyone know if there is a way to remove the cv axle outer to clean it up and stop the popping noise on a 2008 Grizzly 700?
1-19 of 66 Results
Top