Grizzly Riders Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 59 Results
  1. Kodiak/Big Bear/Bruin/Wolverine Discussion
    I recently purchased a 2011 kodiak 350 that has a rear wet brake but it may as well not be there at all since it doesn’t work. If it weren’t for front brakes and engine braking my grandson would be in real trouble. My dealer has suggested that I buy a new rear differential but he has also said...
  2. Grizzly Tech Tips
    I saw there are selling aftermarket cheap front master cylinder on ebay, (grizzly 700)someone have buy it? are good stuff:surprise:? I will appreciate any comment. Thanks
  3. Grizzly Tech Tips
    I recently purchased a 2014 grizzly 450. Im a newbie when it comes to atvs and working on them. Mine has a wet brake in the rear. The rear brake is barely does anything at all. I doubt it's worn out because I only have about 60 hours on it. Can anyone give me some suggestions on what the issue...
  4. General Discussion
    Long story short I had to disconnect my right front caliper to do some other work and now that it's all back together I need to refill and bleed that brake line. First time doing this and to the best of my knowledge the only two 'line ends' I'll need to work with are my right handlebar...
  5. General Discussion
    I'm looking for help, my 700 grizzly has an issue with the left hand brake not working. 160 miles and it quit working
  6. General Discussion
    My 700 has 160 miles on it, my daughter and I were riding last weekend and the left brake lever went totally limp, there's no tension, I can't figure out what happened. Help?
  7. Grizzly Engine & Transmission
    Hello all, I'm new to this forum, and actually a new Grizzly owner. I know there are a lot of threads on clutches, but I can't find one that's appropriate for my situation. I bought an 07 Grizzly 700 from a guy, and knew it needed some work. I'm not very mechanically savvy, so I've been having...
  8. Grizzly Talk
    What type of brake fluid should i add to my reservoir on my 2012 Grizz? It appears to be on the low side. Thanks!
  9. Grizzly Talk
    Anyone ever had a hard time shifting there griz from park to whatever after being out on the lake ice fishing. A guy was telling me that he disconnected the cable so he didn't have to put the brake on to shift it. Just wondering if it's true or not.
  10. Grizzly Talk
    Hi, I'm having a problem with my rear brakes on my '09 Grizzly... I replaced the pads and noticed on the rear left side they were worn very strangely - One at an angle, the other like it was pushed out past the disc. Now, when I put the new pads on, the brakes aren't tight and when I pull the...
  11. New Member Introductions
    When I give the machine gas it feels like the brake is on although it's not. I checked the belt and it looks fine. Just had twins so I aint got much cash to take this thing to the shop. any help would be appreciated. I do have the service manual so I could probably dig into. Thanks
    Mityvac MV8000 Brake Bleeding Kit The original Mityvac hand vacuum/pressure pump kit is used by service professionals worldwide for performing hundreds of diagnostic and mechanical tests and for one-person brake bleeding. Product Features: Hand vacuum pump with 50 mm diameter pressure...
  13. Grizzly Electrical & Lighting
    2011 grizzly 550 Brake light doesn't work ,running light ok. Bulb ok power to rear socket power to switchs on handle bar no light anybody no what's going on
  14. Grizzly Chassis & Body
    Does anyone know how to correctly adjust the rear brakes on a 2008 450 Grizzly? I have found the brake assembly and done some adjusting but I think the brakes may be seized or rusted due to not being used. I also suspect they were never adjusted correctly from the dealership. I hope this is not...
  15. Grizzly Tech Tips
    I put new brake pads on rear of my 07 grizz 450 . I used a c-clamp to depress cup and install new pads. Took it for a ride and noticed an odor of metal. Realised the pads were not free from rotor. When I pull break lever the cup moves in on rotor but doesn't return. How do I remedy this?
  16. Race Driven
    Just in at ATV and Motorcycle brakes or brake pads - Race Driven are our Brake Rotors for Yamaha Rhino's we sell them individually or in kits with our Severe Duty Brake Pads check us out at ATV and Motorcycle brakes or brake pads - Race Driven or call us at 906 420 8009
  17. Race Driven
    I know this is a grizzly site but some of you may also own the new can-am models or have a buddy who does and I just thought I would post this for your info. now has the new brake pad in for the 2012 and 2013 Can-Am Outlander and Renegade Models now available. I know they have...
  18. Grizzly Talk
    aight guys i wish my 700 had a parking brake but can live with it. I was wondering since Suzuki king quads are kinda like a grizz is there anyone that has found a way to incorperate a king quad or any other model parking brake onto a grizz? Just curious
  19. General Discussion
    So why do some people think that having two brake levers are better than one? When you put your quad into three wheel drive and pull only the rear brake lever it will lock up three wheels, one on the front and both rears and when you put it into four wheel lock and pull only the rear brake lever...
  20. Grizzly Tech Tips
    Hello all, This is my first post here, I recently bought a 2005 kodiak 450....this was the 1st year with diff lock. I love it , but my rear brake line and caliper ripped. I suspect I need a new brake line and rear caliper? Has anyone here had to replace this and if so, where did you purchase...
1-20 of 59 Results