Grizzly Riders Forum banner
idle

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 31 Results
  1. Grizzly Engine & Transmission
    just bought a 2009 grizzly 550. when i bought it, it would idle, and while idling would increase rpms on it's own. give it gas, and it would stall. I replaced the plug (ngk), replaced the air filter, and added stabalizer to gas. Idle air control is set at 18 with throttle close and 100 with it...
  2. Grizzly Engine & Transmission
    HI, I was adjusting my idle setting on my grizzly 700 2007 SE. and the rubber tube connected at 21, flew out the throttle body. Does anyone know if ordering the no 12 on this list and putting it back in place will restore the throttle body I mean that hole is so tiny i cant imagine other...
  3. Technical Articles
    I have a 2009 700 grizzly that won't idle. I unplugged the MAP sensor it idles great. Put a new sensor on and it won't start. This bike sat for 5 years. I put a new plug battery and drained the fuel. It also seems like it don't top out like it should. Things I should check?
  4. Grizzly Engine & Transmission
    I've been working on a friend's '98 Grizzly 660 and now I can't get the idle to go down. Put a few good turns on the idle adjustment knob and the idle is still to high. I know its not a carburetor issue because I cleaned and rebuilt it. I honestly just want to get this thing working so I can...
  5. Grizzly Engine & Transmission
    Hey Everyone, I recently picked up a bone stock 08 Grizzly 700 from a friends grandfathers estate sale. It had 1,501 miles on it when I bought it and was visually in good shape - good plastics, racks, seat, etc. It had been sitting in a barn for probably around 3-5 years with little to no...
  6. Grizzly Engine & Transmission
    Hey guys, Im trying to go riding tomorrow and I started my grizzly with half choke it starts right up after it is warmed up i turn off the choke and it dies. I thought that it wasn't warmed up so i kept starting with half choke and slowly reduced the choke and rode it pretty hard. I knew its...
  7. Grizzly Tech Tips
    So, I have an 03 grizzly 660, just replaced the boot between the carb and motor, a "carb kit" and the diaphragm in the top of the carburetor. I finally got the bike put back together enough to start it, and when I do, it idles up super high, like the throttle is stuck, if I put my hand over...
  8. Grizzly Engine & Transmission
    All of a sudden my bike just has a super high idle changed the plug I haven't changed anything but the stator an cover witch I don't think affect the idle is runs fine until u try to stop it won't will keep idling at 4-8 mph only way to stop is turn off or grab the brakes hard I installed a new...
  9. Grizzly Engine & Transmission
    My '03 660 makes a fair amount of engine noise at idle. Sounds like valvetrain clatter to me but don't know for sure. Valves were done at a shop somewhat recently and he said they are in spec and the 660 motor just tends to be noisy. When you give it even slight throttle input it smooths out and...
  10. General Discussion
    I own a 2013 grizzly 700 has 185miles on it... Did my first oil change Friday used yamalube 10-40 and new filter they sold me a crushed washer as well. That I forgot to install.. Took the fourwheeler out Saturday and right away it felt like the clutch wasn't engaging properly or something along...
  11. Grizzly Tech Tips
    i just thought i'd share that a king quad is the same one since the only way to buy on for a grizzly is to buy the whole throttle body. its $140 and a lot better than 600.. gr rules
  12. Grizzly Engine & Transmission
    I just bought a used grizzly 700 with 1100 miles on it and i absouletely love the thing, ive already put 200 miles on it in the past month riding around the lake. the only thing that is weird is when i first start it up it is like the idle goes up and down, it will run smooth and then drop and...
  13. New Member Introductions
    Hi guys im Richard from wales , I've got a grizzly 700 2011 i think my isc valve is playing up I was wondering wether anyone as heard or tryed using a kingquad 700/750 one as I've read on couple of other forums that they fit n work on grizzlys coz u can just buy the isc from yamaha u got buy all...
  14. Official Clutch Forum
    Hi all, I'm new to the forum. I installed a 1mm shim and put the nut and washer back on. I started it up to test and noticed that the Cvt (primary sheave) is spinning on idle. When I view other you tube vids it only seems to spin/engage with throttle. Any help or suggestions about what I have...
  15. New Member Introductions
    I have a 2001 Yamaha Grizzly 600 just picked it up today. The idle spring is broke off of the screw. I was told that i could just grab the spring and twist it and it would adjust the idle. Well when i twist the spring it wont idle up or down....Any suggestions as to get this beast to idle down...
  16. Grizzly Tech Tips
    I have a 07 660 grizzly. When it idles sometimes it will miss and keep idling some times it will just die. After it dies it will start back up tried adjusting the idle screw but it does not help. Sprayed carb with carb cleaner still no diferance. Idles fine with choke on. It runs fine on the...
  17. Grizzly Engine & Transmission
    Hi everyone im new here i got a 09 grizz 550 with 800 miles that wont idle ive tried searching for past posts but didnt really find much on it. Ok so ill start it and have to tap the throttle a lil bit to get it to start and it will run fine above idle at first. If i let off the throttle it...
  18. Grizzly Dyno/Tuning
    I had my valves adjusted a while ago in 09. I've done alot of riding as well as carb jetting since then. I've never been able to get it to idle right in a long time. It skips at idle . When its warmed up it will rev too low and die even after I tried all kinds of idle screw adjustments. At times...
  19. Grizzly Engine & Transmission
    My Grizzly needed an idle adjustment the speed being too high and was 'clunking' into gears. This occurred after using some old but clean fuel when fuel ran out. If I turn the plastic idle knob clockwise one or two turns, the engine coughs and stops. Turning it back to its original position and...
  20. Grizzly Engine & Transmission
    I bought a used 2007 700EPS about a month ago with 1250 miles on it. Occasionally it'll miss at low RPM's, not sitting there idling but just lightly on the gas it'll miss sometimes. Occasionally when starting it then putting in gear it'll cut off as soon as I touch the throttle, it will normally...
1-20 of 31 Results
Top