Grizzly Riders Forum banner
installing
1-10 of 10 Results
  1. General Discussion
    Last time I installed a remote start system it was on an old Dynasty whose wiring was too delicate to work on really. A couple weeks after installation it started ok but a ton of white smoke came from under the dash. I uninstalled the entire system and everything was fine after that. So in...
  2. Grizzly Chassis & Body
    Just purchased this kit from Kolpin which comes with the most unbelievably useless installation instructions I've encountered of late. Anyone ever installed one of these that could post a couple pictures?
  3. General Discussion
    Just unboxed the SW and I'm trying to figure out where some of these parts will be installed. For the most part everything seems straight forward but I'm having trouble deciding where these should go... Piece on the right is the solenoid (and is maybe called a 'contactor' in some of the...
  4. Official Clutch Forum
    I was wondering, if I was going to install a machined sheave with a 1.7 shim, would that defeat the purpose of putting on a machined sheave or would I get a little more tourque out of it. Has anybody tried that setup.
  5. Grizzly Engine & Transmission
    Removed both clutches cause of oil in belt drive, bolts were loose and oil was seeping through, i tried to install secondary (72 ft-lbs of torque) an primary (100 ft-lbs of torque) but i can't hold the clutch to get the right amount of torque. any ideas?
  6. Grizzly Engine & Transmission
    Does anyone have trouble getting their Grizz to fire when its -20 or colder? Running 5-40 synthetic and it turns over ok but is just not rich enough to fire up. If i remove the air filter and stick my mit into the air intake to plug it,it fires right off. Then I can warm it up with the choke as...
  7. Pictures & Videos
    When mounting the new tires last week I decided to make a little video...
  8. Grizzly Tech Tips
    I know this has been done a few times before but I wanted to do this to clarify a few things for those of you thinking of adding a set to your Grizz. This 1.5 extension set was bought from xxbilletxx on E-Bay 4 Yamaha Rhino Polaris Honda Wheel Spacers ATV 1.5" | eBay Parts strait out of the...
  9. Custom Accessories
    well finally had a chance to install them -- there was absolutlly no instructions -- no pictures -- nothing !!! so i just looked at the stuff they gave and went for it -- and yes it was a pain in the azz -- second time around i could prolly do it in 30-45 minutes. picture of right side of...
  10. Grizzly Dyno/Tuning
    UPDATED 10-10-10 SEE BELOW I am adding the following to my 2005 660 Grizzly this weekend - I need jetting advice - Thanks 1. 686 big bore kit 2. HotCam Stage 1 3. HMF performance/utility slip-on exhaust 4. K&N air filter 5. 2000 foot elevation 9-27-2010 installed the Big Bore kit - pain in the...
1-10 of 10 Results
Top