Grizzly Riders Forum banner
issue
1-18 of 68 Results
  1. General Discussion
    Just now rolling over 100k miles. Been feeling some steering weirdness so I get one front wheel up in the air and push at 3 and 9 and sure enough there's some wobble. Pushing at 12 and 6 gives no play at all. Although I'll probably be replacing the worn part myself I need some help diagnosing...
  2. Grizzly Tech Tips
    06 grizzly 660 just installed brand new aftermarket ZoomZoom carb from amazon. It fires right up and idles perfect. Put it in gear and ease on the throttle to roll around the yard and its bogging/sputtering at just past what I would guess is the 1/4 throttle mark(around 10mph), if you give it...
  3. Grizzly Engine & Transmission
    I have a 2015 Yamaha grizzly 700 I just purchased. And after a few weeks of it sitting it is tough to start and also white smoke will come out of the exhaust. The smoke will stop after it warms up and it will start just fine the rest of the day. Any suggestions? It only has 920 miles and 120...
  4. Grizzly Engine & Transmission
    Tried looking around on here before posting but no luck. I drive an 06 660 grizzly. On my last ride when I went to start up it made this loud sort of grinding noise? It actually ended up starting the motor and ran fine after that. I've been looking into a one-way bearing but not sure if that's...
  5. Grizzly Talk
    I have trouble with my Grizzly 660 and have a question. I will appreciate it if someone can answer. I bought some belt off ebay Gatorback I believe anyways the belt wont fit in the back wheel of the clutch setup so when I press the gas it is digging a mark into the back of the belt caseing...
  6. Grizzly Talk
    So I have a 2003 660 grizzly that needs to be choked for about a little less than a minute to get started and needs about 3 minutes to warm up before you can give it gas without it dying. What I have done so far 1, new spark plug, plug was pretty black not brown like i think it should be 2...
  7. Official Clutch Forum
    I have a clunking noise in my CVT side clutch area. I am leaning towards the one way bearing but I really need some guidance before I do a bunch of stuff. What happened was this. Im driving it up a hill and crank into it kinda hard. Front wheels stand up. It comes back down. Not hard or...
  8. Grizzly Tech Tips
    Was in Utah for a few days and it started not wanting to start after sitting for 5-30 min after a few min of just turning over it would start and run fine. I did this multiple time. Got home cleaned it up replaced the fuel (just in case) replaced the plug. and it seemed to be OK. Just starting...
  9. Grizzly Engine & Transmission
    Hey guys, Im trying to go riding tomorrow and I started my grizzly with half choke it starts right up after it is warmed up i turn off the choke and it dies. I thought that it wasn't warmed up so i kept starting with half choke and slowly reduced the choke and rode it pretty hard. I knew its...
  10. Grizzly Tech Tips
    Dear Forum, Can anyone advise what the fixed air jet on the right side of the Mikuni N224.103 carb does?
  11. Grizzly Tech Tips
    hey guys hope ya can help , I seem to be having problem with the shifter on my 2000 grizzly 600 is there an adjustment to the cable that comes from the foot brake? it seems like when the bike is cold I cannot move that damn shifter , but if I stomp on the brake pedal it seems to free up. once...
  12. Grizzly Tech Tips
    Looking for some help! I have a '94 660 that is over heating at low speeds. The kind of slow that you do when your pulling an ATV mower. I usually takes an 1 to 1.5 hours of mowing before it over heats. The fan kicks on; but with the sound of the mower in the back ground I can't hear it if...
  13. Grizzly Engine & Transmission
    I have a 2009 Yamaha Grizzly 550 with 600 miles on it. I was changing the oil the other day and as my brother went to put the oil plug in we noticed that the plug was no longer going in correctly. Now the plug wont tighten and loosely spins, I believe the thread is destoyed, what should I do?
  14. General Discussion
    I'm looking for help, my 700 grizzly has an issue with the left hand brake not working. 160 miles and it quit working
  15. General Discussion
    My 700 has 160 miles on it, my daughter and I were riding last weekend and the left brake lever went totally limp, there's no tension, I can't figure out what happened. Help?
  16. Grizzly Tech Tips
    So, I have an 03 grizzly 660, just replaced the boot between the carb and motor, a "carb kit" and the diaphragm in the top of the carburetor. I finally got the bike put back together enough to start it, and when I do, it idles up super high, like the throttle is stuck, if I put my hand over...
  17. Grizzly Electrical & Lighting
    Hey guys, A couple weeks ago while riding my 09 grizzly, I turned it off. When I turned it on lights/dash came on normal, but when I hit the starter button, I lost ALL electrical power. Key, kill switch, etc wouldn't do anything. I took a look at the relays/fuses with no issues noted. Tried it...
  18. Grizzly Electrical & Lighting
    My grizzlys display lights up wheN I turn the key. But as soon as I press the green button and put the foot break on to start it , the display light goes off . I turn the key off , then on , and no display . Wait 5 minutes , turn the key on , display lights up , try to start it as before and...
1-18 of 68 Results
Top