Grizzly Riders Forum banner
low
1-20 of 29 Results
  1. Official Clutch Forum
    So I'm looking at upgrading my 2011 Grizz 700 to 14" SS212 wheels and 29" or 27" Dirt Commander tires. I know I will lose bottom end and am looking at 1.5 shim with a purple spring. Will this be enough to bring back the quad to usable power levels with a HMF performance exhaust and fuel...
  2. Grizzly Engine & Transmission
    Hey guys I just acquired a 2004 Grizz 660 with only 350 original KMs! I had a new carb and battery installed, valves adjusted and gave it a good cleaning. The bike seems to run well but i just did a compression test and im getting a reading at 115 PSI. From what i read the compression should...
  3. Grizzly Electrical & Lighting
    Hey guys, I have an 03 660 and the diff light just blinks, whether running or not. as soon as I press the diff button, it starts blinking and the servo doesn't do anything and the relay doesn't click. I removed the white relay and tried another one and still nothing. I tested the voltage going...
  4. Grizzly Engine & Transmission
    Hello all! Im a first time poster! . I know there has been a lot of trouble with low gear shifting over the years. But I just got my 05 grizzly 660 put back together and cant get it in low. It goes in all other gears no problem including park. I had to put a crankshaft in it and was wondering...
  5. General Discussion
    My 2013 Yamaha grizz 550 is having trouble shifting into low gear. I read a forum on here about adjusting the shifter linkage. The only problem, I don't know how to remove the side panel in order to get to the shift linkage. And insight on how to get this done?? Any help would be great. Thank You
  6. Grizzly Tech Tips
    Looking for some help! I have a '94 660 that is over heating at low speeds. The kind of slow that you do when your pulling an ATV mower. I usually takes an 1 to 1.5 hours of mowing before it over heats. The fan kicks on; but with the sound of the mower in the back ground I can't hear it if...
  7. Grizzly Talk
    I have a 2014 Grizzly 450. It was submerged recently but the engine never ran while it was under water. I removed and thoroughly cleaned the fuel tank, air intake, carb, and fuel lines. I visually inspected the clutch and belt, both appear to be ok. I drained the oil twice, no signs of...
  8. General Discussion
    Hey guys, as you can see I'm new to the group and I have a question..first, just to go back, I recently bought a 2008 grizzly 700. It had 1400 miles on it, excellent condition. The other day I finally got to hiy the trails again. Before I did, I did my usual pre-ride inspection, which to me up...
  9. Motosport.com
    Always save 20% on OEM ATV Parts at MotoSport.com!!!
  10. Grizzly Electrical & Lighting
    getting ready to install some aftermarket led bars tonight. i would like to tie into the low beam wire. id like to know the location so i dont have to dig around for hours. basically i wan to tie in a spdt relay so it swaps the low beams for the led bar. that way i can cut off the led and...
  11. Grizzly Engine & Transmission
    When I shift into low range the shift lever doesn't go all the way forward and the indicator light doesn't come on. If I move the lever all the way forward so the light comes on it's no longer in low range. Any ideas?
  12. Grizzly Engine & Transmission
    hey guys would like some input on what to do for my grizzly 700 2012..what can i do to improve low end and top end.its all stock nothing done to the grizzly...YET!!
  13. Official Clutch Forum
    Hey guys, I have a 09 700 grizzly that I am getting annoyed with. Everything on the quad is stock except my tires. Currently I have 26x10-12 and 26x12-12 swamp lites, so nothing crazy. Where I ride in Newfoundland marsh areas the ground is extremely spongy and always wet but you can drive...
  14. Grizzly Engine & Transmission
    Hi all, this is my first post on gr. After reading tons on this site, I have been guided in the right direction before with other issues. Im hoping someone can give me some insight into what is going on with my grizz. I recently started noticing that after warming up, my grizz 660 starts cutting...
  15. ATVs For Sale
    I'm selling my immaculate 2011 Yamaha Grizzly 550 with electronic power steering. It only has 18.4 hours and 104 miles on it. As you can see it is blue with the upgraded rims. It has been used around the yard and never been beaten on. It has been washed, waxed, and garage kept after EVERY time I...
  16. Grizzly Engine & Transmission
    this might be long,but please bear with me. my bike has 6000 kms,left my bike outside this weekend,tried to start it up sunday morning(temp was -3C,27F) and it started very,very hard. thought it was valves and checked them and they were good. dicided i would check my compression,the engine was...
  17. Grizzly Talk
    Found a real clean Grizz/Kodiak online, with 9,300KMS/5,778 miles. Wondering how many you folks have on yours?? Or the most you have seen on a Grizz/Kodiak?
  18. General Discussion
    Some one sent me this :s_cool: youtube link. I'm sure some of you's have seen it, but if you haven't, you gotta check this out. Some sick flying here. Enjoy.
  19. Grizzly Tech Tips
    Hey Guys, I have a 03 Grizzly 660 and it will start and run but when the rpm drops below 1000 it will shut off. Spark Stops And Will start back up no problem. i had my timing light hooked to machine and that was how i figured out that it would miss and then lose spark. thanks for checking this...
  20. General Discussion
    Hey guys! Well I finally got the 660 back together and I'm pretty happy. I bought this quad a couple months ago for $1700 with a new 5' cycle country plow. See some before pictures at the old thread. http://grizzlyriders.com/forums/grizzly-talk/7312-just-scored-660-grizz-cheap.html That was...
1-20 of 29 Results
Top