Grizzly Riders Forum banner

problem

  1. Grizzly Tech Tips
    2014 grizzly 700. I went through some water and the EPS started feeling sticky, and got worse to the point that if I tried to turn it would fight back and prevent turning of the handle bars no matter how hard I tried. I opened and die electric greased all connections I could find and it worked...
  2. General Discussion
    Have an '02 Taurus w/ 103k miles and about 6 months ago all the air, heat or a/c, started blowing only out of the defrost vents at the bottom of the windshield. All the settings work correctly except air has stopped blowing from the floor and dash vents entirely. I know the fix on this is...
  3. Grizzly Talk
    I just bought a grizzly 08 700 and all I can get out of it is 47 MPH I know they go faster I've heard 60 to 65 it has 1000 miles I just put new fuel injector in it adjusted the vavles not sure what else it could be o and it has 14 inch rims now not stock 12 but didn't think that would take that...
  4. General Discussion
    Have a '11 Crown Vic with 290k miles and I've been having a problem with the windows fogging up all the way around. The defrost seems to be working about half the time. On humid rainy days it'll work for say a half hour keeping the windows clear, then the windows will fog hard for 10-15...
  5. Grizzly Talk
    I have trouble with my Grizzly 660 and have a question. I will appreciate it if someone can answer. I bought some belt off ebay Gatorback I believe anyways the belt wont fit in the back wheel of the clutch setup so when I press the gas it is digging a mark into the back of the belt caseing...
  6. Grizzly Talk
    I have a 2014 yamaha grizzly 450 eps. When I bought it (used with 1500 miles) the power steering seemed to have been working, but overtime it just started slowly degrading in performance in steering. And when I watch review videos on the the fourwheeler, they talk about how easy the power...
  7. Grizzly Talk
    Hello all, Just bought my first 4x4 quad. 2006 Grizzly 400. Ive been riding and fixing 450s sport quads for years and finally decided to get a 4x4. I was looking over my new purchase and noticed gas was leaking the petcock on the tank. Well I fixed that issue then realized the choke was NOT...
  8. Grizzly Snorkeling
    Whenever I go through powder snow my grizzly wants stall at idle and at low rpms it sounds like it's missing
  9. Grizzly Engine & Transmission
    Greetings, Just bought a Grizzly 700 (with 815 stroker kit installed). There is an engine knock that i can't identify. I pulled the clutch and started it and it is still there. It's staring to look like it might be a rod knock. I wanted to get a second or third opinion before I started...
  10. Grizzly Engine & Transmission
    Hello all! Im a first time poster! . I know there has been a lot of trouble with low gear shifting over the years. But I just got my 05 grizzly 660 put back together and cant get it in low. It goes in all other gears no problem including park. I had to put a crankshaft in it and was wondering...
  11. Grizzly Electrical & Lighting
    I went in the wood last saturday and after when i came back the engine light and EPS came on , i look at the fuse of the esp everything ok , i dont know the problem can you help me please !!
  12. Grizzly Dyno/Tuning
    Gents, My 660 just started idling poorly so I decided to pull the carb off and put a new carb kit in. I cleaned the carb, set the float level to 13-14mm and installed the kit. Initially I inadvertently installed the Pilot jet in the main jet and vise-versa. When the Grizzly started it backfired...
  13. Kodiak/Big Bear/Bruin/Wolverine Discussion
    Hey my kodiak will only start when I hit the 12v solenoid with a wire. Non of my lights work or my winch . I don't know whats wrong with it any help please. I have a brand new battery . My starter doesn't work . Seems like my battery died but it's has great power
  14. New Member Introductions
    I recently picked up a minty 2005 Kodiak 400, but after performing some routine checks, I noticed the right front tire having positive camber to the tune of 3/4". I have checked everything I can think of. No damage, measured everything, bought new upper and lower A arms just to be sure, also...
  15. Grizzly Talk
    Ok so I was having a problem with my 550 going in and out of 4x4. So i cleaned some plugs and it was fine. I went to start it to put it in the garage and nothing. Turn the key and no display, cant start, no lights. Checked fuses by the battery, charge of the battery, and some connections and...
  16. New Member Introductions
    i just bought a 2005 kodiak 500 u have to jump the silinoid to start it and when u get it atarted it wont drive does anyone aknow what the issue could be
  17. Grizzly Tech Tips
    Changed tie rod on my 07 grizz 450 to beefier aftermarket. Set them to same size as old ones but found that the right side wheel points out as you look at it from front. So I set the tires straight then turned the right side tie rod out until it fit the knuckle slot. So one tie rod is now longer...
  18. Grizzly Tech Tips
    Thanks for letting me join. I'm trying to get my 2007 grizzly 660 to start after replacing the throttle cable for the second time in a week. First one was a cheap aftermarket piece, lasted a day. Second is a factory piece. After putting it back together, went to start it and all it does is turn...
  19. Grizzly Engine & Transmission
    I recently bought a 07 700 grizzly with 3200km. I performed a full service and noticed the valves were loud and when I went to adjust them I noticed the left intake valve tappet was scratching the feeler gauge. On further inspection I found that the tappet was worn round, the edges were a bit...
  20. Grizzly Accessories
    well went to use my winch (3500k viper) and had a ton of problems. this blame corded hand control where it plugs into the bike keeps loosing contact. come to find out the 3 male plugs inside the connector keeps pushing in the plug hsg. I fought this for a hour and was very frustrating. its brand...
Top