Search Results for ‘replace’

2009 Grizzly 700 won't start. Code 12 on dash. Tested Crankshaft sensor and it is reading open circuit, instead of 500 ohms. Apparently the stator and crank sensor comes as a unit? If anyone has changed this was there any problems doing so. I found out the dealer wants $425 for the part. Any...

Hi There, I have a 2008 Grizzly 700 EPS. It was bought last January and the EPS never worked since I got it. I have purchased a used EPS motor and would like to replace it myself. Taking it to a ATV shop really isn't an option since the closest one is 4.5 hours away. I have looked at the...

Recently did a boot swap on the old 700 Grizz and found a boogered up thread on the top knuckle ball joint. Can I just order the part and replace this piece myself or does this have to be done by a prof. mechanic? What tool do I use to get it out? Some kind of press maybe? .

I made another video on how to change the servo motors in the older model Yamahas 98-01 with the sealed servo assemblies. Its easy to do and will take you about 10-15 min with basic tools.

I just got a new Titan CV joint boot with clamps and grease. I need to replace the inner rear, anyone have a run down on what all to take apart and how to remove the axle from the differential cup? I've changed one on a Suzuki quad but it's been 10 years ago. The bands I have are different...

is it possible to replace the stock head light without getting into wiring and all that? i am running out of room on my battery for more wires

new to the grizzlys and i got a 125 for 500$ from a guy that was tight on loot, do any car filters fit it?i had a kawasaki dirtbike that would take certain oilfilters for cars , i got the 125 for my kids, i grew up on yamaha dirtbikes [ yz's] and a old 1980xt250! all of em were great machines...

Truck just turned 105,000...2001 F150 4x4 5.4L 2" torsion key suspension 3" body lift ..sets on 35"ers..Might go back down to stock so CV joint want be at such an angle..It dont see much Stump jumping mostly Hi-way and Dads farm out to the shooting range or to ride Atv's/Dirt bikes..Well it blew...

Going to be replacing the one-way bearing on my 02 660. I've got the inner & outer belt housings off, and the sheeves too (primary and secondary). My question is: Is that metal cover with the 9 bolts the part that houses the one-way? The Partshark.com diagram doesn't quite look like what I'm...

My ehs bullet box is f'ed I think (I got it wet while washing the bike) so I was wondering what all you would do? I mean what should I replace it with? I have the bullet billet also, and it is mounted currently on my bar plastic. I never bought the bullet box as it was on eth bike when I...

Have a 07 700 Grizz. This past week at camp, the coolant light came on and checked the level and had to add almost the entire amount of capacity. Less than a half hour of riding and it was back down. Suspect a blown head gasket so dropped it off at the dealer. Any one have an idea as to how much...