Search Results for ‘running’

Soo after the 686 build after first fire up the forewheeler would not run unless I had the choke wide open I was able to rev it up alittle but then she died on me and would not start back up I eventually pulled the spark plug and it looks and smells like burnt oil is this normal during break in...

Soo after the 686 build after first fire up the forewheeler would not run unless I had the choke wide open I was able to rev it up alittle but then she died on me and would not start back up I eventually pulled the spark plug and it looks and smells like burnt oil is this normal during break in...

I have an '02 Taurus with 85k miles on her that I just bought. Today when I was checking something under the hood I noticed this metal line cold and dripping with water... I had the air on but turned to the position of arrows pointing out of the dash and floor vents only. The defrost or...

So I have a 2003 660 grizzly that needs to be choked for about a little less than a minute to get started and needs about 3 minutes to warm up before you can give it gas without it dying. What I have done so far 1, new spark plug, plug was pretty black not brown like i think it should be 2...

2002 grizzly 660. Have put alot of work in it. New carb and choke cable. Timed it right. Valves are set right. Air/fuel mixture set to specs. New spark plug. Everything has been done right. Problem is when i give it throttle it spits and sputters and doesnt want to go, but never shuts off...

I have a 07 450. I noticed one of the axle seals on the rear diff leaked a bit while parked for the winter. This weekend I decided to change the diff seals, clean the carb, and adjust the valves. I did the diff seals yesterday. Took it for a quick spin afterwards. All was good, no leaks...

Hey guys, got an 09 450 thats been sitting for over a year. Cleaned the carb 6 times now. It runs, well idles. If i give it some gas it wants to choke and backfire. If i put my hand over intake tube and do it it runs fine. The second i move my hand it chokes coughs then dies. Fires right back...

Soo I have this problem on 04 kodiak 450,. I turn on temp light comes on.. Goes out, but when I hit throttle the light comes on, and it sounds like engine miss firing or braking up..I have cleaned all connectors and applied die electric grease.. I changed all fuses out..n even cleaned kill...

Hey guys I'm looking for some assistance here. My grandfather passed away recently and has left me a 2000 yamaha big bear 400 4x4. It has not run in at least 3 years. The battery is completely shot and I was not able to pull start it. I removed the fuel line from the carburetor and it was...

My 2003 Kodiak 450 starts great and runs great for approximately 5 minutes then quits. I may get it started again but it will run very rough and quit within 30 to 60 seconds and probably not start again until it has cooled down. I'm thinking it might be the plug or coil. I plan on replacing...

I have a 350 Grizzly and I'm looking for feedback on an issue I'm having. It starts and runs fast idle on full choke. It stalls out after a few minutes and depressing accelerator stalls it immediately. Moving the choke to riding position also causes a stall. Once it stalls it won't start again...

Hey guys, I know the engine ice topic has been discussed and beat to death, but that's not where this is going..yesterday I had some extra time and a little extra pocket change so I figured why not, flushed my grizz till I was blue in the face with distilled water and vinegar, then for another...

I just got done putting on a triangle snorkle kit on my grizz. It is spuddering and backfiring after letting off the throttle. Also does not like to idle. I have k&n air filter and also a dynojet 160 main. The motor also seems to be running hot. Should I be able to dial it in using the fuel/air...

iv got a 04 660 grizzly its bored to 686 and has a hot cam, its intake snorkel its 1 1/2", i know i need to change it to 2" but it blows alittle black smock, the guy i got it from says it is jetted, is it normal to blow alittle black smoke or is it running rich cause my intakes not bug enough...

To get entered for the Ultimate Ride Giveaway!!! Click the image below to get entered now: MotoSport.com is the place to shop for all of your Motorcycle fairings and body parts needs. Be sure to check out our Black Friday and Cyber Monday sales coming soon!!!

Hi all. I joined because I think I'm in over my head on a rebuild and could use some help. I have a 2003 Grizzly 660 with about 700 hours on it. My brother purchased it new in 2003. It sat in storage after he wrecked it due to a stuck throttle cable from 2006 until 2012. I am now trying to...

Sorry for the delay but the GR is back up after being down. Enjoy! :) This message is sponsored by the campaign for a 2up Grizzly!!!

For those of you that have smartphones or tablets, Tapatalk (app) is back up and running on the GR. I personally use this app and love it! It does take a bit to get used to it but after you try it I think most of you will love it for it quick features. Give it a try and let us know what you...

I have a problem with my grizzly not wanting to stay running when it is cold. When it finally warms up it runs like a charm. Is there anything I can do to improve this? It is a 2007 350 grizzly 4x4.

02 660 with powertip and uni wrapped in outerwares she runs hot for some reason and occasionally backfires, also today was sputtering out a bit like it wasn't getting fuel every now and then. Do I need to jet with powertip and uni? Could this cause these problems? My other thought is old or...