Grizzly Riders Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-10 of 11 Results
  1. Kodiak/Big Bear/Bruin/Wolverine Discussion
    Just cleaned the carb on my 2005 Kodiak 450. There's a hose-about 14" long-that secures to rubber damper beneath fuel tank and remains open at top end (assuming a vent). Don't remember removing other end that runs through cut out in damper for fuel line (see pic). Might have been off for some...
  2. General Discussion
    I have a 450 and I noticed a clear vent tube hanging down almost to the ground. The other end is attached to the bottom of the hand pull starter. Sure would like to know where the other end is supposed to go. Thanks
  3. Grizzly Engine & Transmission
    the vent tube below the oil stick is leaking oil help
  4. Grizzly Snorkeling
    I have recently snorkeled and ran vent lines on my 2011 Grizzly 700(tougher than I thought) and have been riding it for say 3 months with no issues...recently I went riding and it was a lot hotter temperature wise and got the gas bubbling in the tank and had some issues with gas slowly but...
  5. Grizzly Talk
    Hey all, Was out riding over the weekend and had to drive though some water. Anyone able to tell me where all my vents are located on my 2013 700 EPS SE? Just wanna make sure I never when over them Thanks gr rules
  6. New Member Introductions
    Hi vent, welcome to the forum! Why not make this your first post and introduce yourself to us?
  7. Grizzly Accessories
    This may sound stupid,,,, but here goes. What is the purpose of the gas tank vent line i see drilled thru the gas cap on some machines? Vents excess pressure, eliminate gas boiling, doe it have a regulator of some kind?? How far into the tank the the line go?
  8. Grizzly Snorkeling
    how many vent lines should i have extended to my snorkel on my 350 2x4
  9. Grizzly Engine & Transmission
    Well like the title says my grizz is blowin oil out this vent tube under the front panel. Any ideas why? I assume Im getting back pressure some where to cause this but I have no idea where. Thanks in advance for any help, I am completely inept at this part of Grizz maintenance. lol
  10. Grizzly Talk
    I was just wondering.. Are there any drain tubes or vent tubes that we need to empty out on the 700? A friend has a 660 and he had a couple of tubes that had clear bags on the ends of them. When they were full of dirt or mud, they had clips on them to take them off and empty them. Does the 700...
1-10 of 11 Results