Grizzly Riders Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Thanks for adding me to your page, i own a 05 660 and it has been everywhere you can think. So i decided to do a tear down and refresh everything front to back seeing as she has close to 20 thousand km on her, so my problem i have run into is replaced all mid section driveline with aftermarket items, short mid shaft, engine coupler and front diff coupler. Measured all purchased items and were same as oem spec. But after 200 ish km the mid shaft pops out of the front differential coupler when loaded up in 4wd but not 2wd, this bike has no lift just a slight engine mod and 27" mega mayhems it is not mudded it is a hunting and fishing machine so upkeep is always done. No sure how to beat this issue any help would be appreciated...thx
 
1 - 1 of 1 Posts
Top